Home

Products

Prices

FAQ's

Contact Us

AA Solar Website

SunPowerPlus Trade Me Site

P O W E R M A S T E R   P U R E   S I N E W A V E I N V E R T E R - C H A R G E R S

LC Series Pure Sinewave Inverter-Chargers SSL Series Pure Sinewave Inverter-Chargers with Solar Controller SI Series Pure Sinewave Stackable Inverter-Chargers

	LC Series Pure Sinewave Inverter-Chargers
	Pure Sinewave inverter with a built in AC Charger and LCD Display. Connect batteries and operate it as a UPS Features   LCD display Multi-stage charger Fast action AC synchronised transfer switch Microprocessor based design Heat-Sink built in internal Soft start AVR design Input & Output isolated Automatic temperature control fan Reverse polarity protection by fuse and diodes Output short circuit protection Temperature protection Overload protection Input low voltage protection Low battery alarm Low battery shut-down Click here for pricing  Model PM-800LC-12 PM-1600LC-24 PM2400-LC-24    Output Power Continuous 800W 1600W 2400W    Max. Surge Power 1600W 3200W 4800W  1. Input Section    Input Nominal Voltage 230VAC    Input Voltage Range 120V~275VAC    Input Frequency 50Hz  2. Output Section    Output Voltage 220VAC/230VAC/240VAC re-settable via LCD panel    Waveform Pure Sinewave    Voltage Regulation (Batt. Mode) < 3% RMS for entire battery voltage range    Output Frequency 50Hz ± 0.1Hz    Efficiency > 75% > 80%    Maximum Load Up to short circuit    Asymmetrical Load Max. Up to nominal output power    Overload and Short Circuit Protection Automatic disconnection    Overheating Temperature Protection Acoustic warning before shut-off, automatic restart    Power Factor 0.8  3. Battery Section    Voltage Range 12VDC (10~16VDC) 24VDC (20~32VDC) 24VDC (20~32VDC)    Input Frequency Range 45~75Hz    Max. Charging Current (5 steps selectable) > 40Amp > 50Amp  4. Display    LCD Display UPS status, Input & Output Voltage Frequency, Load Percentage, Battery Voltage and Percentage, Temperature, Model    LED Display Normal (Green), Warning (Yellow), Fault (Red)  5. Audible Alarm    Battery Mode Beeping every 4 seconds    Low Battery Beeping every second    Overload Beeping twice per second    Temperature Compensation (Option) 3mV / °C cell  6. General Data    AC By-Pass Time (UPS Mode) < 8ms    Operation Temperature -20°C to+55°C    Audible Noise Level Less than 55dBA (at 1M)    Relative Humidity 0-95% non-condensing    Dimensions (L x W x H mm) 435 x 297 x 157 485 x 297 x 198    Weight 16.00kg 24.20kg 26.00kg Click here for a downloadable PDF version of this information
	Back to Top

	SSL Series Pure Sinewave Inverter-Chargers with Solar Controller
	Pure Sinewave Inverter with Battery Charger, Solar Charge Controller and Automatic Transfer Switch ATS Features   Uninterrupted AC power (UPS function) Power Control - dealing with limited generator or shore side power Power Assist - boosting the capacity of shore or generator power LCD display for parameter setting and error messages Programming auxiliary (x3) Optional Remote Control available Battery Charger   Adaptive 4-stage charge characteristic: BULK-ABSORPTION-FLOAT-EQUALISE The right amount of charge: Variable Absorption Time Preventing damage due to excessive gassing: The Battery Safe Mode Less maintenance and again when the battery is not in use: The Equalise Mode 2 outputs to charge 2 battery banks To increase battery life: Temperature Compensation Battery Voltage Sense Click here for pricing  Model PM-1500SSL-12             PM-1500SSL-24 PM-3000SSL-12             PM-3000SSL-24  General  Ventilation Forced Cooling  Operation  Temperature  Storage Temperature -20°C ~ +70°C -25°C ~ +80°C  Protection Output short-circuit, overload, battery voltage too high, battery voltage too low, DC voltage ripple too high, Temperature sensor  Humidity 0~95% (non condensing) Power control and power assist function, uninterrupted AC power for less than 10ms, adaptive 4-stage charger, two output to charge to battery banks, 3x auxiliary relays, battery voltage sensor, battery temperature sensor, remote control port  Inverter  Input Voltage Range 12VDC (9.5~16VDC) 24V (19~32VDC) 12VDC (9.5~16VDC) 24V (19~32VDC)  Output Voltage 230VAC (185~240VAC)  Output Frequency 50Hz ± 0.1%  Output Waveform Pure sine-wave  Output Voltage THD < 5%  No linger load, crest factor 3 : 1  Continuous Power Output (W)  Under 70°C 1500W (No de-ration) 3000W (No de-ration)  Continuous Power Output (W)   Over 70°C 0W (Shut-down) 0W (Shut-down)  Maximum Power 3000W 6000W  Maximum Efficiency 82% 84% 84% 86%  Zero-load Power 12W 18W  Charger  Input Voltage Range 200~250VAC  Input Frequency 45-55Hz  Power Factor 1  Charge Characteristic 4-stage adaptive: BULK-ABSORPTION-FLOAT-EQUALISE  Maximum DC Voltage Ripple < 1.25 Vrms  Charge Current House Battery 70A 40A 140A 70A  Charge Current Starter Battery 4A  Absorption Voltage Default 14.4V 28.8V 14.4V 28.8V  Float Voltage Default 13.8V 27.6V 13.8V 27.6V  Equalise Voltage Default 13.2V 26.4V 13.2V 26.4V  Output Charge Voltage(Min~max) 8V~16V 11V~32V 8V~16V 11V~32V  Battery Temperature Sensor BTS-3  Solar Charge  System Voltage Ratings 12 VDC 24 VDC 12 VDC 24 VDC  Current ratings-Battery Charge Control 40A  Accuracy ≤ 0.1% ± 50mV  Min. Voltage to Operate 9V  Max. Solar Array Voc 140V  Max. Operating Voltage 68V  Total Current Consumption While operating -25mA, at idle -3mA  High Temp Shut-down 90°C disconnect solar, 70°C reconnect solar  Transient Surge Protection   - Pulse Power Rating                                          - Response 4500 watt < 5 nanosecond  Environmental  Ambient temperature -40 to +45°C  Storage temperature -55 to +85°C  Humidity 100% (non condensing)  AC Input Switch  AC IN Terminal Circuit Breaker 15A 30A  Switch-over Time     - inverter to AC input                                       - AC input to inverter 0 ms 0 ms  Mechanical  Cabinet / Protecting Class Aluminium / IP20  Dimensions  (H x W x D) Wall: 298 x 256 x 368 mm Table: 189 x 285 x 494 mm Wall: 355 x 256 x 368 mm Table: 189 x 285 x 708 mm  Weight 30kg 35kg Click here for a downloadable PDF version of this information
	Back to Top

	SI Series Pure Sinewave Stackable Inverter-Chargers
	Pure Sinewave Inverters with AC Charger and Solar Charger (Option) + one more design [stackable function] You may parallel SI Series, according to your requirements Features   More inverters stackable 3 Phase connectable Uninterrupted AC power (UPS function) Power Control - Dealing with limited generator or shore side power Power Assist - Boosting the capacity of shore or generator power LCD display for parameter setting and error messages Programming auxiliary relay (x3) Battery Charger   Adaptive 4-stage charge characteristic: BULK-ABSORPTION-FLOAT-EQUALISE The right amount of charge: Variable Absorption Time Preventing damage due to excessive gassing: The Battery Safe Mode Less maintenance and aging when the battery is not in use: The Equalise Mode 2 outputs to charge 2 battery banks To increase battery life: Temperature Compensation Battery Voltage Sense Click here for pricing  Model PM-1500SI-12 PM-3000SI-24  Inverter  Input Voltage Range 12VDC (9.5~16VDC) 24VDC (19~32VDC)  Output Voltage 230VAC (185~240VAC)  Output Frequency 50Hz ± 0.1%  Output Waveform Pure sine wave  THD < 5%  Power Factor All loads  Switch-on Behaviour Nominal output voltage within 20ms  Continuous Output Power at 25°C 1500W 3000W  Continuous Output Power at 40°C 1200W 2400W  Maximum Power 3000W 6000W  Maximum Efficiency 88% 92%  Zero-load Power 12W 18W  Charger  Input Voltage Range 230 VAC (200~250VAC)  Input Frequency 50Hz (45~55Hz)  Power Factor 1  Charge Characteristic 4-stage adaptive  Maximum DC Voltage Ripple < 1.25 Vrms  Charge Voltage "Absorption" 14.4V 28.8V  Charge Voltage "Float" 13.8V 27.6V  Output Charge "Voltage" (Min, Max) 8V, 16V 11V, 32V  Charge Current House Battery 70A 70A  Charge Current Starter Battery 4A  AC Input Switch  Protected by Thermal Circuit Breaker 16A 30A  Switch-over Time Inverter to AC Input 0 ms  Switch-over Time AC Input to Inverter 0ms  Detection Time AC Input Fault 4 ms to 20 ms  Trip Level Mains to Inverter 180VAC  Trip Level Inverter to Mains 187VAC  Min-Max Frequency Range 45~55Hz  General  Power Control Yes  Power Assist 10A 20A  Auto Transfer Switch 16A 30A  Multi-purpose Relay 3 relays  Protection Output short circuit, Overload, Battery over voltage, Battery under voltage, Battery reverse polarity detection, Over temperature, High input voltage ripple  Operating temperature range -20°C to +50°C (fan assisted cooling)  Humidity max 95% (non condensing)  Weight 15kg 28kg  Dimensions (L x W x H) 380 x 285 x 185 mm 550 x 285 x 185 mm  Options  Battery Temperature Sensor (BTS) Compensation for the battery charging voltage and current Click here for a downloadable PDF version of this information
	Back to Top

Updated May 2011